1.Switch on the receivers first! Then the ear monitoring transmitters.(開機時,先將接收器打開)
2.Avoid a mix of different compander systems of transmitter and receiver.
3.Consider correct placement of clip on microphones and cables.
4.Apply new batteries properly.(儘可能使用充電電池,掌握電池狀況)
5.Allow a minimum of 20dB audio headroom.(接受器維持最低20dB的音壓)
6.Adjust the input sensitivity at the transmitter.(調整發射器的靈敏度)
7.Never operate two transmitters at the same frequency.(別將兩個發射器用在同個頻率上)
8.Keep a distance of app. 1cm between body and transmitter aerial (身體避免與接受器直接接觸)
9.Distance between transmitter and receiver antennas should not fall below 4m.
10.Switch off receivers if transmitters of a multichannel system are not activated.
11.Diversity switching must operate frequency during the range testing.
12.Avoid rf-carner spacing below 0.375mHz
13.Don't mix frequency bands of ear monitors and wireless microphones.(別將不同器材混用在同個頻帶)
14.Allow a minimum distance of 5m between IEM and microphone antennas.(IEM與麥克風天線間隔5m以上)
15.Apply active antenna combiners for multichannel ear monitoring.
16.Don't cascade combiners.
17.Apply directional aerials for IEM transmitters.(避免發射與接收端中間有障礙物)
18.Apply rf cable with 50 Ohm impedance.(選用阻抗50歐姆的線材)
19.Apply mono mode for critical IEM conditions(wide range)
20.Mount the earpieces carefully.
21.Prepare spare systems.